海上稠油油田蒸汽吞吐产量确定新方法

针对目前蒸汽吞吐产量预测模型假设条件简单、普适性差等问题,一般采用测试法和类比法综合确定海上稠油油田蒸汽吞吐初期产量。由于目前海上油田通常只开展常规测试,无法直接获得热采开发初期产量。笔者提出海上稠油油田蒸汽吞吐初期产量确定新方法,建立蒸汽吞吐相对于常规开发的初期产量倍数预测模型,通过蒸汽吞吐产量倍数,将常规测试确定的产量转化为蒸汽吞吐产量。研究表明,蒸汽吞吐初期产量倍数主要受储集层渗透率、原油黏度、注入强度、蒸汽干度等因素影响,利用正交试验设计和多元回归等方法,建立海上稠油油田蒸汽吞吐初期产量倍数与油藏地质参数及注入参数之间的非线性预测模型,该模型经实际生产数据验证,预测误差小于5%,可靠性高,能够为海上稠油油田蒸汽吞吐初期产量的确定提供依据。     

浮法玻璃熔窑火焰空间石油焦部分替代重油燃烧的数值模拟

针对浮法玻璃熔窑火焰空间建立模型并进行了数值模拟，在保证热值相同的前提下，对比研究了重油燃烧及将石油焦部分替代重油燃烧时的流场分布特征。结果表明，石油焦部分代替重油燃烧后，两种燃料可很好地混合燃烧，窑炉内温度制度基本不受影响；石油焦着火时间比重油长，两种燃料混合燃烧时平均着火点滞后于仅使用重油时，且燃烧路径更长，燃烧时产生了大量CO，整个火焰空间及烟气出口处NOx的平均排放量与仅使用重油相比降低了30.02%，NOx减排效果明显。     

氮对镀锡钢板的强化作用

通过物理化学相分析研究了3种不同氮含量镀锡板中固溶氮、化合氮的含量,结合相关理论计算了镀锡板中氮的固溶强化和析出强化对强度的贡献。结果表明:随着总氮含量从0.0021%提高到0.0103%,钢中化合氮含量下降10.1%,但是AlN析出相中的氮的含量上升10.7%。氮在提高镀锡板强度方面发挥重要作用,钢中总氮含量提高0.0082%,其对屈服强度的贡献值提升约30 MPa。     

Identification of heavy metal-contaminated Tegillarca granosa using laser-induced breakdown spectroscopy and linear regression for classification

Tegillarca granosa (T. granosa) is susceptible to heavy metals, which may pose a threat to consumer health. Thus, healthy and polluted T. granosa should be distinguished quickly. This study aimed to rapidly identify heavy metal pollution by using laser-induced breakdown spectroscopy (LIBS) coupled with linear regression classification (LRC). Five types of T. granosa were studied, namely, Cd-, Zn-, Pb-contaminated, mixed contaminated, and control samples. Threshold method was applied to extract the significant variables from LIBS spectra. Then, LRC was used to classify the different types of T. granosa. Other classification models and feature selection methods were used for comparison. LRC was the best model, achieving an accuracy of 90.67%. Results indicated that LIBS combined with LRC is effective and feasible for T. granosa heavy metal detection.     

Study on migration characteristics of heavy metals during oil sludge incineration

Experimental and simulation studies on the migration characteristics of heavy metals during the incineration of OS were conducted with a tube furnace reactor and thermodynamic equilibrium calculation software FactSage, respectively. The results showed that when the incineration temperature increased from 800°C to 1100°C, the release rates of heavy metals such as Cr, Pb, Cu, Zn and Ni increased gradually and reached the maximum at 1000°C. When the excess air ratio increased from 1.0 to 1.4, the release rates of heavy metals such as Cr, Pb, Cu, Zn and Ni first decreased and then became steady. The content of gaseous hydroxide of Cr and gaseous chlorides of Pb and Cu increased while the chemical forms of Zn and Ni did not change obviously with the increase of combustion temperature or excess air ratio.     

[可靠性建模及试验技术]重型机床液压元件油液污染退化量分布剖面可靠性建模

针对重型机床液压系统故障频繁且多与油液中的固态颗粒污染物相关的问题，进行了油液污染趋势变化试验。通过时域分析获得了油样颗粒数的有量纲和量纲一参数，通过Q-Q图和K-S检验分析有量纲参数，污染颗粒数是退化量服从正态分布的退化数据。进行了油液污染与环境相关性分析试验，采用相关系数法分析得到，颗粒数变化量与一定范围内的温度、流量、压力的相关性小；将液压元件分为管路、阀、过滤器三类，用直径5 μm左右的颗粒和直径大于15 μm的颗粒分别研究管路及阀件的堵塞和磨损情况，以过滤器过滤精度大小的颗粒研究过滤器的堵塞情况，设定ISO4406标准20/17级对应的颗粒数为阈值，利用退化量分布建立了液压元件单一故障模式的可靠性模型；利用竞争失效模型将上述模型融合为多故障模式下的可靠性模型。     

Synthesis of ZnS nanoparticles of required size by precipitation in aerosol microdroplets

Zinc sulphide (ZnS) nanoparticles were prepared by an aerosol method from zinc acetate and sodium sulphide (Na₂S) aqueous solutions. Aqueous solution of zinc acetate was dispersed into the form of microdroplets, which were introduced by airflow to vigorously stirred aqueous solution of Na₂S, which was in excess. Microdroplets served as microreactors, so the reaction took place only in limited volume. Particle size distribution was studied by transmission electron microscopy and by dynamic light scattering measurements. In this work, the equation that allows us to predict the final size distribution of ZnS nanoparticles using exact concentration of zinc acetate was derived and ZnS nanoparticles with predicted mean particle diameter around 50 and 70?nm were successfully synthetised.     

Oil Demand and Stocks

Current data of world oil demand. This includes international bunkers and refinery fuel. Updated on a monthly basis. Current data of oil demand from counties such as Canada, the United States of America, Japan, OECD Europe, Belgium, France, Germany, Italy, Netherlands, Spain, Sweden, the United Kingdom, Australia, Mexico, Republic of Korea, and Turkey. Updated on a monthly basis. Current data for crude oil and refined product stocks in Canada, Chile, Mexico, the United States (Western Hemisphere), France, Germany, Italy, Netherlands, Spain, the United Kingdom and Other Europe (Europe), Japan, Republic of Korea, Other Pacific (Asia-Pacific), and Total OECD (Table 12.1) Current data for refined product stocks in the OECD Western Hemisphere, OECD Europe, OECD Asia-Pacific and Total OECD. Products include gasoline, diesel and gasoil, and heavy fuel oil. Updated on a monthly basis (Table 12.2).     

土壤重金属光谱检测方法的应用研究

针对土壤重金属,在简述其危害的基础上,对其光谱检测方法具体应用进行深入分析,以此为实际的重金属检测工作提供理论参考,保证检测结果准确性与可靠性。